Nissan Rogue 2.5 Oil Capacity by Generation
Rogue 2.5L oil-capacity chart with filter-included values, generation breaks, refill procedure, dipstick checks, FAQs, cautions, and manufacturer sources.
The 2014–2020 Rogue 2.5L QR25DE owner-manual row is approximately 4-7/8 US qt (4.6 L) with filter; the redesigned 2021 Rogue 2.5L PR25DD row is approximately 5-3/8 US qt (5.1 L).
The 2014–2020 Rogue 2.5L QR25DE owner-manual row is approximately 4-7/8 US qt (4.6 L) with filter; the redesigned 2021 Rogue 2.5L PR25DD row is approximately 5-3/8 US qt (5.1 L). That published capacity is a service starting point, not permission to empty the last fraction of a bottle into the crankcase. Drain time, oil temperature, cooler volume, filter construction, vehicle angle, and residual oil all affect the amount required to reach the dipstick's full mark.
The 2021 platform break is also an engine-family break: the earlier QR25DE and later PR25DD share nominal displacement but not the same service refill. Read the VIN/model year and emissions label before choosing a row. This guide separates the generations in the table, keeps filter-included and filter-excluded figures distinct, and explains a repeatable refill check. Do not add a full five-quart jug and then another half-quart without checking. Refill below the reference amount, run the engine, inspect the filter and drain plug, wait on level ground, and approach the H mark gradually.
Refill below the listed total first, start the engine long enough to fill the filter, inspect for leaks, shut it down, wait on level ground, and finish by dipstick. That process protects against both an underfilled engine and the aeration, leakage, or catalyst trouble that overfilling can cause.
Interactive Nissan Rogue 2.5L oil-service workflow
Branded downloads includedPNG and PDF exports carry the TorqueSheet logo, torquesheet.com, source-page URL, and republishing attribution request. The PDF source link is clickable.
Follow the workflow from vehicle identification through final dipstick verification. Published capacities are starting quantities, not a substitute for the level check.
Nissan Rogue 2.5 Oil Capacity
| APPLICATION / ITEM | SPECIFICATION | NOTES |
|---|---|---|
| 2014–2020 QR25DE with filter | 4-7/8 US qt | 4.6 L; owner-manual reference quantity |
| 2021 2.5L PR25DD with filter | 5-3/8 US qt | 5.1 L; verify later model years |
| Rogue Sport / Hybrid / 1.5T | Separate manual row | Do not use this 2.5L chart |
| Final level | Dipstick after drain-back | Nissan capacities are approximate |
Nissan calls both quantities approximate and makes the dipstick the final authority. The 2021 redesign changed the engine from QR25DE to direct-injected PR25DD, so rounding the two rows into one five-quart answer hides a real service difference.
The generation break that matters for Rogue 2.5L
The 2021 platform break is also an engine-family break: the earlier QR25DE and later PR25DD share nominal displacement but not the same service refill. Read the VIN/model year and emissions label before choosing a row. Read the model-year and engine row together; a badge, displacement, or oil cap by itself may span more than one internal engine revision. The values below are drain-and-refill quantities with the filter unless the row says otherwise.
Do not add a full five-quart jug and then another half-quart without checking. Refill below the reference amount, run the engine, inspect the filter and drain plug, wait on level ground, and approach the H mark gradually. Use the oil grade and manufacturer approval from the same model-year manual as the capacity. Capacity, viscosity, and approval are three separate specifications.
Oil-capacity chart for Rogue 2.5L
Use the chart as an application lookup. The 2021 platform break is also an engine-family break: the earlier QR25DE and later PR25DD share nominal displacement but not the same service refill. Read the VIN/model year and emissions label before choosing a row. A capacity printed beside the wrong engine code is not “close enough”; even engines sharing the same displacement can have different pans, filters, coolers, or drain-back behavior. If the vehicle has been swapped, rebuilt, or fitted with an aftermarket pan, use the installed hardware manufacturer's capacity and calibration marks.
The most common current application begins near 4-7/8 US qt. Begin below that amount and finish by measurement. The difference between the add and full marks is often about one quart, but do not assume that relationship when the dipstick is aftermarket, damaged, or paired with a non-original tube. Investigate a reading that remains absent or implausibly high.
Do not add a full five-quart jug and then another half-quart without checking. Refill below the reference amount, run the engine, inspect the filter and drain plug, wait on level ground, and approach the H mark gradually.
Common causes of a capacity mismatch
Nissan calls both quantities approximate and makes the dipstick the final authority. The 2021 redesign changed the engine from QR25DE to direct-injected PR25DD, so rounding the two rows into one five-quart answer hides a real service difference. If the verified dipstick result and the expected quantity disagree materially, stop and identify the cause instead of choosing whichever number is more convenient.
- The lookup used the model name but not the model year or engine code.
- The quoted figure excluded the filter while the filter was replaced.
- The vehicle was not level or the oil had not drained back before checking.
- An oil cooler, remote filter, aftermarket pan, engine swap, or incorrect dipstick changed the system.
- The old filter gasket remained on the housing or a leak began after startup.
- The crankcase was filled to the advertised capacity without a final dipstick check.
Nissan Rogue 2.5L specifications can change by model year, engine, platform, wheel, and installed component. Confirm the VIN or engine identity, part numbers, fastener condition, and the current manufacturer instructions before service.
Procedures used with this specification
These steps are the same for every vehicle in this family, so they are documented once rather than repeated on each page. The values above remain specific to this Nissan Rogue 2.5L.
Nissan Rogue 2.5 Oil Capacity by Generation FAQs
How much oil does the Rogue 2.5L take?+
The 2014–2020 Rogue 2.5L QR25DE owner-manual row is approximately 4-7/8 US qt (4.6 L) with filter; the redesigned 2021 Rogue 2.5L PR25DD row is approximately 5-3/8 US qt (5.1 L). Confirm the year/engine row and finish by the dipstick rather than treating the capacity as an exact pour-in amount.
Technical sources
TorqueSheet favors engine- and component-specific manufacturer instructions over unsourced universal values.
12018 Nissan Rogue Owner's Manual — capacitiesPrimary Nissan manual for the second-generation Rogue 2.5L QR25DE refill and dipstick procedure.↗22021 Nissan Rogue Owner's Manual — capacitiesPrimary Nissan manual for the redesigned Rogue 2.5L PR25DD application.↗3Nissan manuals and guidesPrimary Nissan model-year owner-manual library.↗