A change this small is generally treated as a straight substitution. Speedometer error stays under three percent and the clearance designed around 235/40R18 is largely preserved. The section width still changes by 0.39 inches, so confirm your rim width suits 245/40R18 before ordering.
Want to try other sizes against these? Open this comparison in the interactive tool.
Effectively the same rolling diameter
These two sizes differ by only +1.2% in overall diameter, which for most purposes means they are interchangeable. Your speedometer, odometer and gearing barely notice a change this small.
What does change is the width. Section width moves from 9.25 inches to 9.65, and sidewall height from 3.7 to 3.86. So this is a handling and appearance decision rather than a fitment one.
The practical checks are narrower than usual here: confirm your rim width suits 245/40R18, and check inner clearance if the tire is getting wider. Height is not the issue with this pairing.
235/40R18 and 245/40R18 measured against each other
Both sizes reduced to the same units. The diameter row is the one that drives everything else on this page — ride height, gearing, speedometer accuracy and odometer readings all follow from it.
| Measurement | 235/40R18 | 245/40R18 | Difference |
|---|---|---|---|
| Overall diameter | 25.4" | 25.72" | +0.31" (+1.2%) |
| Section width | 9.25" (235 mm) | 9.65" (245 mm) | +0.39" |
| Sidewall height | 3.7" | 3.86" | +0.16" |
| Rim diameter | 18" | 18" | +0" |
| Circumference | 79.8" | 80.79" | +0.99" |
| Revolutions per mile | 794 | 784 | −10 |
| Ride height at axle | Baseline | +0.16" | +0.16" |
What the dial shows against how fast you are going
Your speedometer was calibrated to 235/40R18, which turns about 794 times per mile. Fit 245/40R18 at about 784 revolutions per mile and the same wheel speed now represents a greater road speed than the instrument assumes. The error is 1.2% at every speed, so it grows in absolute terms the faster you go.
| Speedometer reads | You are actually doing | Difference |
|---|---|---|
| 30 mph | 30.4 mph | +0.4 mph |
| 45 mph | 45.6 mph | +0.6 mph |
| 60 mph | 60.7 mph | +0.7 mph |
| 75 mph | 75.9 mph | +0.9 mph |
Over distance the same proportion applies to the odometer. Every indicated 1,000 miles on 245/40R18 is really about 1012 miles covered — worth knowing on a leased vehicle, where recorded mileage and real mileage drift apart.
What this particular change asks you to check
- Section width grows by 0.39 inches, so the tire sits closer to the strut and the inner liner on both sides.
- Overall height grows by 0.31 inches, of which 0.16 inches goes upward into the arch — check at full lock and full compression.
- Both sizes use a 18-inch rim, so the existing wheels carry over if their width suits the new section.
- Speedometer error of 1.2% — check whether your vehicle supports recalibrating for a new tire size.
- Confirm the load index on 245/40R18meets or exceeds the figure on the vehicle's tire placard, particularly if the vehicle tows or carries load.
- On all-wheel-drive and four-wheel-drive vehicles, change all four together — mismatched rolling circumferences load the differentials and transfer case continuously.
235/40R18 vs 245/40R18 FAQ
Is 245/40R18 bigger than 235/40R18?+
245/40R18 measures 25.72 inches in overall diameter against 25.4 inches for 235/40R18. That makes it 0.31 inches taller, a change of +1.2%. It is also 0.39 inches wider in section width.
Will 245/40R18 fit in place of 235/40R18?+
The diameter change is +1.2%, which falls inside the 3% envelope generally treated as a routine substitution. That makes it a plausible swap, but the section width also changes by 0.39 inches, so confirm the rim width suits the new size and check clearance at full lock.
How much lift does 245/40R18 give over 235/40R18?+
0.16 inches at the axle — half the diameter difference. The other half of the change goes upward into the wheel arch, which is where fitment problems usually appear.
How far off will my speedometer be?+
The speedometer will read low by about 1.2%. At an indicated 60 mph you would actually be travelling about 60.7 mph, and every indicated 1,000 miles would really be about 1012.
Do I need to regear for 245/40R18?+
A +1.2% change is small enough that most vehicles absorb it without complaint. Regearing is usually considered from around 10% upward, or sooner on a vehicle that tows regularly.
What is the revolutions-per-mile difference?+
235/40R18 turns about 794 times per mile and 245/40R18 about 784 — a difference of −10 revolutions. That figure is what the speedometer and odometer are calibrated against, which is why both readings shift.
These are nominal figures. Every number above is calculated from the marked size. Real tires vary from nominal by a few millimetres between manufacturers, and by more as tread wears or pressure changes. Use this to plan and to check a quote — measure the actual tire before committing to a tight fitment.