Honda CR-V 2.4 Oil Capacity by Generation
CR-V 2.4L oil-capacity chart with filter-included values, generation breaks, refill procedure, dipstick checks, FAQs, cautions, and manufacturer sources.
The 2012–2014 CR-V 2.4L lists 4.2 US qt (4.0 L) including filter; the 2015–2019 2.4L application commonly lists 4.6 US qt (4.4 L).
The 2012–2014 CR-V 2.4L lists 4.2 US qt (4.0 L) including filter; the 2015–2019 2.4L application commonly lists 4.6 US qt (4.4 L). That published capacity is a service starting point, not permission to empty the last fraction of a bottle into the crankcase. Drain time, oil temperature, cooler volume, filter construction, vehicle angle, and residual oil all affect the amount required to reach the dipstick's full mark.
The meaningful break is the 2015 engine revision. The earlier fourth-generation 2.4L uses 4.2 qt with filter, while the later direct-injected 2.4L commonly uses 4.6 qt. This guide separates the generations in the table, keeps filter-included and filter-excluded figures distinct, and explains a repeatable refill check. Do not apply the 1.5L turbo's 3.7-qt row to a 2.4L CR-V, and do not assume every 2017–2019 trim has the same engine.
Refill below the listed total first, start the engine long enough to fill the filter, inspect for leaks, shut it down, wait on level ground, and finish by dipstick. That process protects against both an underfilled engine and the aeration, leakage, or catalyst trouble that overfilling can cause.
Interactive Honda CR-V 2.4L oil-service workflow
Branded downloads includedPNG and PDF exports carry the TorqueSheet logo, torquesheet.com, source-page URL, and republishing attribution request. The PDF source link is clickable.
Follow the workflow from vehicle identification through final dipstick verification. Published capacities are starting quantities, not a substitute for the level check.
Honda Crv 2.4 Oil Capacity
| APPLICATION / ITEM | SPECIFICATION | NOTES |
|---|---|---|
| 2012–2014 2.4L with filter | 4.2 US qt | 4.0 L |
| 2015–2019 2.4L with filter | 4.6 US qt | 4.4 L; verify exact trim/market |
| Without filter | Use matching manual | Do not mix generation rows |
| Final check | Dipstick after about 3 minutes | Vehicle level; do not overfill |
Honda kept the 2.4L displacement while revising the K24 engine and sump for 2015. The fifth-generation 2.4L was limited to particular trims/markets, so the emissions label and exact manual remain part of the lookup.
The generation break that matters for CR-V 2.4L
The meaningful break is the 2015 engine revision. The earlier fourth-generation 2.4L uses 4.2 qt with filter, while the later direct-injected 2.4L commonly uses 4.6 qt. Read the model-year and engine row together; a badge, displacement, or oil cap by itself may span more than one internal engine revision. The values below are drain-and-refill quantities with the filter unless the row says otherwise.
Do not apply the 1.5L turbo's 3.7-qt row to a 2.4L CR-V, and do not assume every 2017–2019 trim has the same engine. Use the oil grade and manufacturer approval from the same model-year manual as the capacity. Capacity, viscosity, and approval are three separate specifications.
Oil-capacity chart for CR-V 2.4L
Use the chart as an application lookup. The meaningful break is the 2015 engine revision. The earlier fourth-generation 2.4L uses 4.2 qt with filter, while the later direct-injected 2.4L commonly uses 4.6 qt. A capacity printed beside the wrong engine code is not “close enough”; even engines sharing the same displacement can have different pans, filters, coolers, or drain-back behavior. If the vehicle has been swapped, rebuilt, or fitted with an aftermarket pan, use the installed hardware manufacturer's capacity and calibration marks.
The most common current application begins near 4.2 US qt. Begin below that amount and finish by measurement. The difference between the add and full marks is often about one quart, but do not assume that relationship when the dipstick is aftermarket, damaged, or paired with a non-original tube. Investigate a reading that remains absent or implausibly high.
Do not apply the 1.5L turbo's 3.7-qt row to a 2.4L CR-V, and do not assume every 2017–2019 trim has the same engine.
Common causes of a capacity mismatch
Honda kept the 2.4L displacement while revising the K24 engine and sump for 2015. The fifth-generation 2.4L was limited to particular trims/markets, so the emissions label and exact manual remain part of the lookup. If the verified dipstick result and the expected quantity disagree materially, stop and identify the cause instead of choosing whichever number is more convenient.
- The lookup used the model name but not the model year or engine code.
- The quoted figure excluded the filter while the filter was replaced.
- The vehicle was not level or the oil had not drained back before checking.
- An oil cooler, remote filter, aftermarket pan, engine swap, or incorrect dipstick changed the system.
- The old filter gasket remained on the housing or a leak began after startup.
- The crankcase was filled to the advertised capacity without a final dipstick check.
Honda CR-V 2.4L specifications can change by model year, engine, platform, wheel, and installed component. Confirm the VIN or engine identity, part numbers, fastener condition, and the current manufacturer instructions before service.
Procedures used with this specification
These steps are the same for every vehicle in this family, so they are documented once rather than repeated on each page. The values above remain specific to this Honda CR-V 2.4L.
Honda CR-V 2.4 Oil Capacity by Generation FAQs
How much oil does the CR-V 2.4L take?+
The 2012–2014 CR-V 2.4L lists 4.2 US qt (4.0 L) including filter; the 2015–2019 2.4L application commonly lists 4.6 US qt (4.4 L). Confirm the year/engine row and finish by the dipstick rather than treating the capacity as an exact pour-in amount.
Technical sources
TorqueSheet favors engine- and component-specific manufacturer instructions over unsourced universal values.
12012 Honda CR-V Owner's Manual — specificationsPrimary Honda manual listing 4.2 qt (4.0 L) including filter for the 2012 2.4L engine.↗22019 Honda CR-V Owner's Manual — specificationsPrimary Honda manual used to distinguish the 2.4L LX application from the 1.5L turbo and its separate refill quantity.↗3Honda owner's manual libraryPrimary Honda year/model manual lookup.↗